Maintenance

5Reset the lamp usage time

Please perform the operation indicated below in the standby mode (*).

Operation with the Projector

Press the INPUT, PORTRAIT, FREEZE OFF and FREEZE/CAPTURE buttons si- multaneously, then press the input selector and still picture buttons simultaneously.

Operation with the Remote Control

Resetting of the lamp usage time cannot be performed with the remote control.

The LAMP/COVER LED will flash green following this and projection will start.

* The power plug is plugged into a power outlet and only the ON/STANDBY LED is lit red.

• Do not reset the lamp usage time without replacing the lamp.

CAUTION The likelihood of the lamp rupturing becomes higher when the lamp has been used in excess of 2000 hours.

6Check that the indication of the lamp us- age time has become "0 H" as illustrated

in the diagram to the right.

If the usage time has not been reset, please reset it by following Step 5 again.

Check the lamp usage time by pressing the menu button of the remote control to display the menu, then use the scroll ◀▶ button to display the setup setting.

If the lamp is used without resetting the usage time, the correct lamp usage time will not be known;

CAUTION therefore, be sure to reset the usage time after lamp replacement. When the indication exceeds 2000 hours, the projector will be forced to turn off the projection lamp.

NOTE:

In the interest of safety, the lamp will not light when the lamp unit cover is off.

The lamp units that are available separately are sold together with an air filter as a set in a lamp kit; therefore, please also re- place the air filter at the same time as lamp unit replacement. (See Page E-50.)

Lamp units can be disposed of using the same disposal method as household fluorescent lamps in accordance with the regu- lations of your region.

E-49