B

Power Cord Set Requirements

3-Conductor Power Cord Set

The wide range input feature of the notebook permits it to operate from any line voltage from 100 to 120 or 220 to 240 volts AC.

The power cord set received with the notebook meets the requirements for use in the country where the equipment is purchased.

Power cord sets for use in other countries must meet the requirements of the country where the notebook is used. For more information on power cord set requirements, contact a Compaq authorized reseller or service provider.

General Requirements

The requirements listed below are applicable to all countries:

The length of the power cord set must be at least 1.5 m (5.00 feet) and a maximum of 2.0 m (6.50 feet).

All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the country where the power cord set will be used.

The power cord set must have a minimum current capacity of 10 amperes and a nominal voltage rating of 125 or

250 volts AC, as required by each country’s power system.

The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector, for mating with the appliance inlet on the back of the notebook.

Maintenance and Service Guide

B–1

Page 193
Image 193
Compaq N620C, N600c, N610V manual Power Cord Set Requirements, Conductor Power Cord Set