Compaq N610V, N600c, N620C manual Reverse the preceding procedure to replace the processor

Removal and Replacement Procedures

g.Top cover (Section 5.12)

h.System board (Section 5.13)

i.Heat sink (Section 5.15)

2.Turn the system board bottom side up with the rear panel facing you.

3.Insert the tip of a flat-blade screwdriver into the slot on the processor locking screw.

4.Turn the screwdriver counterclockwise 1 to release the processor (Figure 5-34).

5.Remove the processor from the socket on the system board 2.

✎When installing the processor, make sure the gold triangle 3 is in the lower right corner.

Figure 5-34. Removing the Processor

Reverse the preceding procedure to replace the processor.

Maintenance and Service Guide 5–51