496679
21
The display shows the time.
5. Key in two digits for the year, followed by .
4. Key two digits for the month (01 for January, to 12 for December) followed by .
3. Key in two digits for the day followed by .
The display shows the date.
2. Press 6.
1. Key in User 01 access code.
To set the time and date:
The control unit contains an internal clock/calendar that runs as long as there is power present (mains or stand-by battery). The system uses this clock to mark the time and date on the system log. If the power supply3%##4fails for any reason, and the stand-by battery is low, then the system loses track of the correct time and date. You may also need to change the time if you live in a country that uses summer/winter time. User 01 is the only access code that can change the time and date.
-#'
Note that neither the Installer nor the user can erase the log.
Setting the Time and Date
| 4. Special Functions |
Tel Line Fault | Communications (telephone line) fault detected. |
Tel Line Rstr | Communications restored. |
Comms Fail | The communicator failed to report. |
AC Fail | Mains failed. |
AC Restore | Mains restored. |
Low Battery | Standby battery is low. |
Low Batt Rstr | Standby battery restored. |
Batt Missing | 12V supply from standby battery not present. |
Batt Missing Rstr | 12V supply from standby battery restored. |
Batt Load Fail | Standby battery has failed load test. Call Installer. |
Aux DC Fail | Power supply to wired detectors has failed. |
Aux DC Fail Rstr | Power supply to wired detectors restored. |
In the log user codes are represented by numbers as follows:
U00 | Installer | U19 | Idle |
U01 | User code 1 | U20 | Telecommand |
... | ... | U21 | Keyswitch |
U16 | User code 16 | U22 | Remote Reset |
U17 | Duress code | U23 | Download |
U18 | Control Unit | U24 | Virtual keypad |
| | | |