4. Special Functions
Introduction
You can perform a number of other functions from the keypad, apart from setting and unsetting the system. These functions are:
[Access code] + A (B, C or D) + | Omit zone while setting. |
[Access code] + | Omitting 24 hour zones. |
[User 01 Access code] + 4 | Changing access codes and user |
| names. |
[Access code] + 5 | Reading the system log. |
[User 01 Access code] + 6 | Setting the time and date. |
[Access code] + 7 | Turning the chime on or off. |
[Access code] + 8 | Testing the sounders. |
[Access code] + 9 | Testing the zones. |
[Access code] + 0 | Call out to <Downloader>. |
To use these functions you must key in your access code and then press a number key. The rest of this section describes each function in turn.
Omitting Zones
Your system may be programmed so that you can omit individual()*+,,detectors when setting the system. Ask your Installer which zones can be omitted. Note that omission is not permanent. You must omit the zone every time you set the system.
2.Press the appropriate Level key, and then within 5 seconds press .
3. Press the number of the zone you want to omit (for example, key in 2 to
omit zone 2) and then press . |
|
|
|
|
| ||
If the system accepts the omission the |
|
| |
sounder gives a double beep and the |
|
|
|
display shows: | "beep beep" |
| |
To omit more zones press again |
| ||
within 5 seconds. |
|
|
|
Note: If you decide you have omitted the wrong zone, press followed by the zone number and to reinstate the zone.
16 | 496679 |