22
496679
This display shows:
3. Walk round your premises and trigger each detector in turn (except 24 hour or personal attack detectors).
2. Press 9.
1. Key in your access code.
You can set the system so that it will allow you to walk round the premises and test each of the detectors (a walk test). Choose a time567when the premises are empty to carry out the test, otherwise people may trigger any movement detectors before you do, and confuse the results of the test.
If any detector fails the test then call your alarm company and ask them to check the system.
Note: If your system is fitted with 24 hour or personal attack detectors, you cannot walk test them. If you wish to test them call your alarm company.
(Press 7 again to toggle Chime OFF.) 3. Press .
Testing the System Bell Test
You can test that all the sounders and the strobe are working, as follows: 1. Key in your access code.
2. Press 8.
The system turns the external sounder, strobe, internal sounder(s) and keypad sounders on for three seconds each, one after the other. Note: The strobe flashes for 10 seconds in order to give you time to see it.
Walk Test
The display shows:
2. Press 7.
1. Key in your access code.
Turning the Chime On/Off
The display shows the new time and date:
Your system may be programmed so that a chime tone sounds12*")whenever certain doors are opened while the system is unset. To turn Chime on or off:
6. Key in two digits for the hour followed by . (Use the 24 hour clock.)
7. Key in two digits for the minutes, followed by .
4. Special Functions
%&#&##'(
