Page 14 of 21 WR 3M
2. Enter the 1, 2, or 3-digit LOCK code with the UP or DOWN Scroll
Key.
3. Depress Radio Button ┌ 3 ┐. The Station is now unlocked.
Resetting the Special Functions to Factory Default Settings
1. Select the Special Functions Menu 1.
2. Depress and hold down Radio Button ┌ 3 ┐.
3. Then Depress the UP and DOWN Scroll Keys simultaneously.
"FSE", Factory Setting Enabled appears in the display.
The Rework Station is now reset to the factory default settings.
4. Exit the menu with Radio Button ┌ 3 ┐ (EXIT).
7.1 Selecting Menu 2 Special Functions
Special Functions Navigation
LEVEL
ID
FCC
PICK-UP
↑ ┌ 1 ┐
↓ ┌ 2 ┐
EXIT ┌ 3 ┐
1. Select the desired channel ┌ 1 ┐, ┌ 2 ┐ or ┌ 3 ┐ for entering the
special functions.
2. Depress and hold down the UP and DOWN Scroll Keys
simultaneously.
"– 2 –" appears in the display after 4 seconds.
3. Release the Scroll Keys.
Selection of the special functions of Menu 2 is activated.
The settings can now be made.
− Select menu items with Radio Buttons ┌ 1 ┐ and ┌ 2 ┐.
− Exit the menu with Radio Button ┌ 3 ┐ (EXIT).
Defining the Maintenance Level of the Vacuum System ( VAC and
bar )
− The value is shown in mbar at which the electric vacuum gauge
issues a vacuum level warning signal. The LED (3) of the vacuum
pump switches from green to red. The set value is dependent on
the desoldering tiplets used.
− Factory setting: -600 mbar
Settable: -400 mbar to -800 mbar
1. Select the menu item LEVEL in Menu 2.
2. Set the vacuum value LEVEL with the UP or DOWN Scroll Key.
3. Proceed to the next menu item with the Radio Button ┌ 1 ┐ (back)
or ┌ 2 ┐ (forward) or exit the menu with Radio button ┌ 3 ┐ (EXIT).
Setting the Station Identification ( REMOTE ID code )
When the optional USB port is used, several WR 3M Rework
Stations can be activated and remote-controlled. Each Station