Cornelius 322 manual Installation Instructions For Mounting On Drink Dispensers

Also check to see if the float valve is functioning properly and the correct water level is being maintained. Adjust if necessary.

2.Check the refrigerant circuit by making sure that the condenser fan is running. (This will be evident by air noise) Is the compressor running? (Feel the casing for vibration). Is the evaporator getting cold?

3.Check bin--harvest switch operation. )See procedure in manual).

WATER

DISTRIBUTOR

HOLES

ILL025

INSTALLATION INSTRUCTIONS FOR MOUNTING ON DRINK DISPENSERS

For mounting ice machine on to an ice/drink dispenser you should have the proper install kit.

Checkout Procedure For Harvest Bin Switches

Turn on the ice machine and move the evaporator curtain(s) away from the evaporator(s). The ice machine should then shut--off in approximately 10 seconds. (See detail A & B).

Slowly let the evaporator curtain(s) move back toward the evaporator(s) until the bottom edge of the curtain(s) is at least at the bent edge of the water reservoir or closer to the evaporator. With the curtain(s) at that position, the machine should start. (See detail C).

		DETAIL ”B”
	ACORN NUT
CURTAIN EDGE	SENSOR
	THERMO-
MAGNET	WELL
		BOTTOM
	PROXIMITY	EDGE OF
		EVAPORATOR
EVAPORATOR	SWITCH	CURTAIN
CURTAIN	ACORN NUT	DETAIL ”C”
WATER
RESERVOIR
ill 021	DETAIL ”A”

Adjustment Procedure For Harvest Bin Switches.

If adjustment is necessary, loosen acorn nuts and move proximity switch closer to the curtain(s) and make sure the curtain is properly mounted. (See detail A).

166240008 8 3/17/95