Cornelius PR150 BC manual Adjusting Water-To-Syrup “Ratio” Brix Of Dispensed Product

1.Remove cover from the dispensing valve by lifting the front cover up 1/4 inch and pulling forward.

2.Install syrup diversion tube assembly on the dispensing valve by pushing rubber end of the syrup diversion tube onto the syrup outlet of the inner nozzle.

3.Measure the water flow rate by dispensing water into a graduated cup for a set period of time.

NOTE: Adjusting screw stops are built into the valve to prevent leakage when the screws are adjusted too far clockwise. Stop adjusting clockwise when turning resistance increases. Turn the screw coun- terclockwise 1–1/2 turns after the stop are contacted.

4.Turn the water flow regulator adjusting screw to the left (counterclockwise) to decrease the water flow rate or turn the adjusting screw to the right (clockwise) to increase the water flow rate, then recheck the flow rate. Adjustments should be no more than 1/4 turn at a time.

5.Remove syrup diversion tube from the dispensing valve, then install cover on the dispensing valve.

WATER FLOW

REGULATOR

SYRUP FLOW

REGULATOR

INNER NOZZLE

Counterclockwise	NOZZLE
to Decrease
Clockwise	SYRUP DIVERSION
	TUBE
to Increase
	RATIO CUP

FIGURE 3. UF-1 DISPENSING VALVE

ADJUSTING WATER-TO-SYRUP “RATIO” (BRIX) OF DISPENSED PRODUCT

(see Figure 3)

NOTE: Make sure the dispensing valve water flow rate is as desired before adjusting the valve for Wa- ter-to-Syrup ‘‘Ratio’’ (Brix) of the dispensed product.

Adjust Water–to–Syrup “Ratio” (Brix) of the dispensed product by using ratio cup (P/N 311100000) and syrup diversion tube assembly (P/N 319540000) as follows:

1. Remove cover from the dispensing valve by lifting front cover up 1/4 inch and pulling forward.

620918702 10