Pre-Installation
System Requirements - Windows 98 or later.
Compliant with USB 1.1 requirements for bus powered devices. USB Hub supports low power or self powered USB devices (each USB port provides 100 mA).
Pre-installation Guidelines - Before installing your DPA,
observe the following guidelines:
CONNECTION WARNING - Never connect the DPA directly to the telephone line or telephone wall outlet. Use the procedures in this User's Guide to avoid damaging your DPA.
USB DRIVERS - The DPA uses standard Microsoft drivers. When installing the DPA for the first time you will be prompted by the computer to install/load drivers. Follow the prompts to identify the DPA to your operating system.
TELEPHONE LEVEL SWITCH - Set the Telephone Level switch on the DPA for the telephone you are using (refer to the Level Switch Setting Table on page 14). Switch setting #3 is used on the majority of digital telephone systems.
TELEPHONE SET VOLUME CONTROL - The Telephone Set Volume Control (handset and/or speakerphone volume) may impact your connection speed. KONEXX recommends that the volume control be set in the
SPEAKERPHONES - If the attached telephone has speakerphone capability, do not use speakerphone mode. Speakerphone mode disconnects the handset jack used by the Modem Konnector to send and receive data.
DIALING - Configure your modem for Tone Dialing (Go to Start…Settings…Control Panel…Modems…Dialing Properties…click on TONE DIAL ).
MODEM SPEAKER CONTROL AND VOLUME - The telephone handset is deactivated when your modem is in use. You can use the “M1” command to enable the modem speaker and the “L3” command to set its volume. You can then "listen in" on dialed calls to monitor their status. Refer to your modem manual for more information.
