STOVE SPECIFICATIONS

TABLE 2 shows the physical dimensions of the Crossfire product.

CROSSFIRE

DIMENSIONS (IN INCHES)

STOVE HEIGHT (At Front)

22.5“

STOVE DEPTH (From Shroud)

14.0“

STOVE WIDTH (Rear)

26.0“

STOVE WIDTH (At Shroud Mount)

25.5“

STOVE WEIGHT (empty)

220 pounds

SHROUD WIDTH, (standard)

42.0”

SHROUD HEIGHT (standard)

30.0”

SHROUD WIDTH, (oversized)

48.0”

SHROUD HEIGHT (oversized)

32.5”

TABLE 2: CROSSFIRE, CF-O4 SPECIFICATIONS

ELECTRICAL REQUIREMENTS

The Crossfire Model CF-04 requires a code compliant grounded 120 volt, 15 ampere, and 60 hertz electrical outlet. The Crossfire utilizes only a fraction of the 15 amperes rating of a code compliant outlet but it is strongly recommended that a dedicated circuit (versus a branch electrical circuit) be provided for the stove to ensure no interference from other electrical appliances.

GOLD DOOR CARE

All Crossfire plated doors and trim (gold or nickel) should be wiped down BEFORE THE FIRST FIRE to prevent potential permanent damage to occur to plating. For general cleaning, use a dry cloth and wipe the plated surface to ensure the luster and beauty lasts a lifetime. Always use an approved glass cleaner (i.e. Windex, Glass Plus) and a lint free soft cloth to polish the doorframe. DO NOT use abrasives, like steel wool, brass polish, or cleaners, like Comet. Improper cleaners can permanently scratch the finish. A damaged door can be returned to Country Flame for refinishing but repair is expensive. Proper care of the Crossfire plated door and other plated trim will ensure these parts will survive a lifetime of use. A painted Crossfire door requires no specific care.

OPTIONAL FEATURES

There is an ever growing list of options for Country Flame stove products, including the Crossfire. Contact an authorized Country Flame dealer for more information.

OPTIONAL THERMOSTAT OPERATION

A thermostat option is available for the Crossfire. With the optional thermostat installed, the Crossfire can be turned on and off based on a preset temperature according to the customer’s desire.

CROSSFIRE IS COLD

•Start up the Crossfire by first installing pellets into the burn pot.

•Hold the Intelli-ChoiceControl Board on/off switch until the power light turns green and the igniter light begins to slowly blink on and off.

•Once a pellet fire has been established, hold the Intelli-ChoiceControl Board on/off switch until the auger light blinks rapidly on and off. Release the Intelli-ChoiceControl Board on/off switch.

•If the #3 heat setting lights up, the Crossfire will begin feeding corn. Ensure proper air setting for the temperature set. If the auger light goes back to blinking on and off slowly, wait until the stove warms up further and then repeat the process until Heat Setting #3 is obtained.

CROSSFIRE IS HOT

•If the stove is set to a heat setting greater than 1 when the thermostat calls for heat, the Intelli-ChoiceControl Board will remember this setting and return to this setting any time heat is called for by the thermostat.

Version 2.0e

22