APPENDIX B: MAINTENANCE GUIDE (CONT’D)

 

Replacing the Door / Glass Gaskets

To replace the gaskets, remove the door by lifting it

 

 

straight up off its hinge pins and laying it face down

 

 

on a soft surface. Remove the door gasket (you

 

 

may need to use pliers) and then remove the glass

 

 

retaining clips and remove glass. Strip off old

 

 

gasket around glass and clean glass well. Clean out

 

 

old stove gasket material from gasket track. Once

 

 

the door and glass are clean, apply gasket material

 

 

to glass surface and return glass to door, securing

 

 

with clips (Use care not to over-tighten). Then

 

 

apply a generous bead of gasket cement into the

 

 

track. Position the NEW gasket into track and

 

 

gently press into door. Trim off any excess gasket

 

 

and wipe away excess cement. Let the cement set

 

 

24 hours before placing door back on unit and using

 

 

the unit. Gasket material and cement may be

 

 

obtained from your dealer.

 

Replacing the Glass

Remove the door gasket (you may need to use

 

 

pliers) and then remove the glass retaining clips and

 

 

remove glass. Replacement glass should be 0.200”

 

 

(5mm) thick. Overall size of the glass is 16”

 

 

(405mm) wide by 11” (279mm) high, cut to an

 

 

irregular shape to fit the door front. Your unit uses

 

 

Euro Kera or a similar ceramic type high temp

 

 

glass. Do not use any other than recommended

 

 

glass type in this unit. Replacement glass may be

 

 

obtained from your dealer. Clean out old stove

 

 

gasket material from gasket track. Once the area is

 

 

clean, apply gasket material to new glass surface

 

 

and return glass to door, securing with clips (Use

 

 

care not to over-tighten).

 

Adjusting the Doors

The doors of your Crossfire Stove may need some

 

 

adjustment due to shipping vibrations, jarring

 

 

during installation and extended use. It is important

 

 

that the Crossfire door fit properly and remain

 

 

airtight. Periodically check the alignment of the

 

 

doors. To adjust the door, loosen the Allen bolts in

 

 

the hinge and adjust the door accordingly. When

 

 

completed, use a piece of paper between the door

 

 

and the stove to ensure a proper seal. The paper

 

 

should not pull out easily once the door is closed

 

 

and latched.

Version 2.0e

46