FIGURE 12 demonstrates a direct connect (simplest) vent system attached to a Country Flame Harvester. There are a number of critical factors that need to be considered when using the direct connect method. What is the clearance from the ground to the jet cap? What amount of snow (or drift) can be expected (anything blocking the exhaust will inhibit proper Harvester combustion?) What is the exterior covering on the house (combustible or non-combustible?) What are the prevailing wind directions (strong winds blowing directly into the exhaust pipe will cause combustion problems?) What is the ground covering around the jet cap (dry grass can be ignited from sparks causing a house fire?) Despite the direct connect low initial cost, improper planning can lead to expensive problems. Consult with a professional.

FIGURE 13: FLEXIBLE LINER VENT SYSTEM INSTALLATION

FIGURE 13 demonstrates a freestanding connection to an existing masonry fireplace chimney. The freestanding connection will require the use of at least one clean out tee located at the back of the Harvester. The diameter of the clean out tee pipe and other vent pipe will be determined by the length of overall pipe required in a specific application. In many cases an additional clean out tee will be required inside the chimney. Failure to provide clean out access to this kind of installation will require additional services of a certified chimney sweep. Chimney sweeps maintain the equipment necessary to professional clean a Harvester installation that does not provide clean out tees. A certified installer will take all site specific requirements into account when completing an installation for the homeowner.

Version 2.0b

29