APPENDIX B: MAINTENANCE GUIDE (CONT’D)
| Replacing the Door / Glass Gaskets | To replace the gaskets, remove the door by lifting it | |
| straight up off its hinge pins and laying it face down | |
| on a soft surface. Remove the door gasket (you | |
| may need to use pliers) and then remove the glass | |
| retaining clips and remove glass. Strip off old | |
| gasket around glass and clean glass well. Clean out | |
| old stove gasket material from gasket track. Once | |
| the door and glass are clean, apply gasket material | |
| to glass surface and return glass to door, securing | |
| with clips (Use care not to | |
| apply a generous bead of gasket cement into the | |
| track. Position the NEW gasket into track and | |
| gently press into door. Trim off any excess gasket | |
| and wipe away excess cement. Let the cement set | |
| 24 hours before placing door back on unit and using | |
| the unit. Gasket material and cement may be | |
| obtained from your dealer. | |
| Replacing the Glass | Remove the door gasket (you may need to use | |
| pliers) and then remove the glass retaining clips and | |
| remove glass. Replacement glass should be 0.200” | |
| (5mm) thick. Overall size of the glass is 16” | |
| (405mm) wide by 11” (279mm) high, cut to an | |
| irregular shape to fit the door front. Your unit uses | |
| KERA LITE®, or a similar ceramic type high | |
| temp glass. | Do not use any other than |
| recommended glass type in this unit. Replacement | |
| glass may be obtained from your dealer. Clean out | |
| old stove gasket material from gasket track. Once | |
| the area is clean, apply gasket material to new glass | |
| surface and return glass to door, securing with clips | |
| (Use care not to | |
| Adjusting the Doors | The doors of your Harvester Pellet Stove may need | |
| some adjustment due to shipping vibrations, jarring | |
| during installation and extended use. As it is | |
| important that the doors fit properly to remain | |
| airtight, it is suggested that you periodically check | |
| the alignment of the doors. To adjust the doors | |
| ……………. |
|
Version 2.0b | 45 |