Collector Box Installation
The following procedure includes all of the steps necessary for the installation of the Collector Box on the DR LEAF and LAWN VACUUM.
1.Place the projecting edges of the two Side Panels in the slots on the trailer as shown.
Note: The Side Support plates are loosely mounted to the Side Panels to allow for easy alignment and expansion of the plastic. Align the holes in the projecting edges with the holes in the trailer frame. Secure them at each end to the trailer frame with the 5/16" x 2" Wing Screws. Install a Lock Washer followed by a Flat Washer on each Wing Screw. The Wing Screws are inserted through the frame from the outside (Figure 9).
Note: The side support plates may have swung inside during shipping.
2.Tip the Centrifugal Separator at a 45° angle and slide it between the secured sides on the trailer with the hose protruding along the right side of the trailer pointing toward the front (Figure 10).
3.Place the left edge of the Centrifugal Separator on top of the left side panel. (Figure 10).
Tip: This can be accomplished easier with two
(2)people.
4.Lift the hose side of the Centrifugal Separator and place it on top of the right side panel; align the holes in the top edges of the side panels with the protruding pins from the Centrifugal Separator and secure in place with the flexible latches (Figure 11).
Tip: Push out in the middle of the top of the side panel to help seat the pin in the hole in the middle of the top edge of the Side Panel.
Panels | Wing | |
Screw | ||
Inserted | ||
4 places | ||
in Slots | ||
|
Figure 9
Figure 10
Latches
Push Out
Pin in
Hole
Figure 11
14 | DR COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions |
