Connecting the Blower Inlet Vacuum Hose to the Hose Adapter
The following procedure includes the steps necessary for connecting the Blower Inlet Vacuum Hose of the DR LEAF and LAWN VACUUM to the Hose Adapter.
Tools May Be Needed:
Wire Cutters or Hack Saw
Knife
Screw driver or Nut driver
1.Connect the hose from the Blower Inlet to the Hose Adapter by aligning the two flexible latches and slipping the end of the hose over the adapter (Figure 22).
2.Pull and hook the two flexible latches into place (Figure 22) to secure the hose.
Tip: If the latches do not align, loosen the hose clamp on the Inlet Hose and rotate the hose connector into alignment.
Hose Clamp
Pull & Hook
Inlet Flexible Latch
Hose
Hose
Adapter
Figure 22
DR COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions | 21 |