Chapter 4: Operating Your DR LEAF and LAWN VACUUM
This chapter covers the procedures for starting and stopping your new DR LEAF and LAWN VACUUM and also discusses basic operation features.
Before Starting the Engine
WARNING! Inspect the area in which you will be working. The site must be free of potentially hazardous obstacles such as stones, metal or glass. Pile sticks that you intend to chip separately and away from the vacuum site. Also make sure there won't be people or animals in the area around the DR LEAF and LAWN VACUUM.
1.Connect the DR LEAF and LAWN VACUUM to your lawn tractor (see page 18) and raise the three Support Legs into the mounting frame by repositioning the quick release pins into the lower holes provided in the leg shafts (see Figure 18 on page 18).
2.Check the engine oil level every time you use the machine (see Figure 25 on page 23).
3.Check the gasoline level (see Figure 25).
4.Turn the Gas
Starting & Stopping
1.When starting a cold engine; push the Choke Control lever to the right (CHOKE) and the Throttle Control lever to the far right (Figure 26).
2.Grasp the recoil starter handle and slowly pull until you feel resistance, then pull the cord with a smooth accelerating motion to start the engine. One or two pulls usually starts the DR LEAF and LAWN VACUUM.
3.After the engine starts, slowly push the Choke Control lever to the left (RUN) position. Wait until the engine runs smoothly before each choke adjustment (Figure 26). For best engine performance, it is recommended that the engine be operated with the throttle in the fast (Rabbit) position (Figure 26).
4.To stop the engine, move the throttle to the slow (Turtle) position allowing the engine to idle, then move the lever to STOP (Stop Sign) position (Figure 26).
Important! The engine will not start if the Safety Interlock Switches are not properly adjusted. See page 16, Figure 14 and page 37, Figure 43.
Gas Shut Off
Choke
Throttle
Figure 26
24 | DR COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions |
