Universal Hitch Plate Installation
The following procedure includes the steps necessary for installing the Universal Hitch Plate to your lawn tractor. The Hitch Plate is designed to accommodate a variety of mounting positions to achieve the proper tongue height for the DR LEAF and LAWN VACUUM.
Note: Depending on the size and shape of your lawn tractor, you may not need the Universal Hitch Plate. If you do need it, it may be installed in one of four different configurations. Pick the configuration that aligns best with the existing mounting holes and avoids areas with other equipment such as the gas tank, battery or electrical wiring. You may need to drill mounting holes if none are available. A typical installation is shown in Figure 16.
WARNING! In determining which hitch plate configuration to use, note the location of the battery, fuel tank, electrical wiring, etc. on your tractor so as not to damage them with the mounting hardware. Determine the best orientation of the hitch plate to avoid hitting other items while drilling any holes.
Tool Needed:
1/2" Wrench or Socket
3/8" drill bit & drill (if necessary)
Using the (4) 5/16 x 1" Bolts, Lock Nuts & (8) Flat Washers supplied (one washer, inside and outside on each bolt); install the Hitch Plate centered on your lawn tractor approximately 13" (10" - 14") from the ground (Figure 16) by mounting the Hitch Plate in either of the illustrated configurations (Figure 16).
Approx. 13"
Narrow
Side Up
Wide Side
Hitch Plate Configurations |
|
|
Approx. 13" | ||
Figure 16 | Ground | |
Important! The top surface of the Hitch Plate should be approximately 13" from the ground.
DR COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions | 17 |
