Dumping
WARNINGS!
Always shut off the tractor engine and the vacuum engine and use caution when dumping the Collector Box load.
The load may have shifted against the rear panel. Push down on the Dump Handle when releasing the Dump Lever to prevent the Tilt Bed from suddenly tipping.
1.Disconnect the Collector Box Hose from the Blower Exit Elbow by releasing the two flexible latches (Figure 34) and separate the hoses.
2.Remove the Rear Panel of the Collector Box by releasing the six (6) fasteners located at the sides, top and bottom of the panel. Lift the Rear Panel off the mounting pins on the Collector Box Cover.
3.While holding down on the Dump Handle, pull the Dump Lever (Figure 35) to unlock the Tilt Bed and then raise the Tilt Bed using the Dump Handle (Figure 36).
4.After dumping the load, lower the Tilt Bed until the Dump Lever locks into place (Figure 36), and replace the Rear Panel.
5.
Pull & Unhook Latches
Figure 25
Collector
Box Hose
Blower Exit Elbow
Figure 34
Pull Dump Lever
Locked
Position
Dump | Dump |
Handle | Handle |
| Hold |
| |
| Down |
Figure 35 | Figure 36 |
30 | DR COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions |
