NEUTON EM 4.1 Cordless Electric Mower Safety & Operating Instructions 11
Step 3: Attach the UpperHandlebar Assembly
The black connecting knobs (used to connect the
upper and lower handlebar sections together) are
attached to the lower handlebar sections.
1. Remove the b lack connector knobs and
connector bolts from the upper ends of the
lower handlebars.
2. Line up the holes of the upper handle bars
with the holes in the lower handlebar sections.
Let the upper handlebar assembly lean on the gr ound
during this process (Figur e 3). It is easier to start with the
upper assembly in this position, so you don’t have to hold
and balance it while connecting the sections. Once you
have the handlebars loosely connected, you can swing the
upper assembly into place and tighten it fur ther.
3. Slide the connector bolts (from inside to
outside) through the holes in the upper and lower
handlebar sections on eac h side of the mower. Screw
on the black connector knobs, then hand-tighten
them just enough to hold the upper and lower
handlebar sections together on each side.
4. Swing the upper handlebar assembly into position.
The bars will line up and slide into place (Figur e 4) .
Hand-tighten the connecting knobs until they are snug.
To save space, you c an loosen thes e connecting knobs to drop the upper handlebar assembly onto
the mower’s deck when you have placed the mower i n storage.
Step 4: Cut and Remove theStrapping Holding the Battery inPlace
The battery is shipped in the mower.Be fore using the
mower, open the batter cover, then cut and remove the
strapping used to hold the batter y in place.
To easily open the batter y cover, press down on the
mower body next to the indentation by the battery cover
handle, then pull the cover open (Figur e 5).
Figure 3. Leaning the upper handlebar
assembly on the floor to help connect it
Figure 4. The upper handlebar
assembly after being attached.
Figure 5. Opening the battery cover