!WARNING
●To avoid injury, never use the saw without the cover plate secure in place. It keeps the arbor bolt from falling out if it accidentally loosens, and helps prevent the spinning blade from coming off the saw.
●Make sure the collars are clean and properly arranged. Lower the blade into the table and check for any contact with the metal base or the turn table.
THE LASER GUIDE (FIG. N)
1.To turn laser on, press on/off rocker switch (1) to “ON” position.
2.To turn off laser, press on/off rocker switch to “OFF” position.
Fig. N 1
THE LASER BEAM
!WARNING
For your own safety, never connect the plug to power source outlet until all the adjustment steps
are complete and you have read and understood the safety and operational instructions.
Your tool is equipped with the Laser Trac® cutting guide using Class II laser beam. The laser beam will enable you to preview the saw blade path on the stock to be cut before starting the miter saw. This laser guide is powered by the transformed alternating current supply directly through the power lead. The
saw must be connected to the power source and the laser on/off switch must be turned on for the laser line to show.
!WARNING
AVOID DIRECT EYE CONTACT
●Laser is radiated when laser guide is turned on. Avoid direct eye contact. Always
●Laser Warning Label: max output <1mW DIODE LASER:
●NOTE: All the adjustments for the operation of this machine have been completed at the factory. Due to normal wear and use, some occasional readjustments may be necessary.
●
●
●Do not attempt to repair or disassemble the laser. If unqualified persons attempt to repair this laser product, serious injury may result. Any repair required on this laser product should be performed by authorized service center personnel.
22 
