Craftsman 139.5391 owner manual Connect Door Arm to Trolley, Sectional Doors only

INSTALLATION STEP 12

Connect Door Arm to Trolley

Follow instructions which apply to your door type as illustrated below and on the following page.

SECTIONAL DOORS ONLY

•Make sure garage door is fully closed. Pull the emergency release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the pulley) about 8" (20 cm) as shown in Figures 1, 2 and 3.

•Figure 1:

-Fasten straight door arm section to outer trolley with the 5/16"xl" clevis pin. Secure the connection with a ring fastener.

-Fasten curved section to the door bracket in the same way, using the 5/16"xl-1/4" clevis pin.

•Figure 2:

-Bring arm sections together. Find two pairs of holes that line up and join sections. Select holes as far apart as possible to increase door arm rigidity.

•Figure 3, Hole alignment alternative:

-If holes in curved arm are above holes in straight arm, disconnect straight arm. Cut about 6"

(15 cm) from the solid end. Reconnect to trolley with cut end down as shown.

-Bring arm sections together.

-Find two pairs of holes that line up and join with bolts, lock washers and nuts.

•Pull the emergency release handle toward the opener at a 45° angle so that the trolley release arm is horizontal. Proceed to Adjustment Step 1, page 27. Trolley wilt re-engage automatically when opener is operated.

HARDWARE SHOWN ACTUAL SIZE

©©0

Nut 5/16"-18 Lock Washer 5/16" Ring Fastener

C °lC ol

Clevis Pin	Clevis Pin		Hex Bolt
5/16"x1" (Trolley)	5/16"x1-t/4"	(Door Bracket)	5/16"-18x7/8"

Pulley			'
L.-
i			i
8" (20 cm)		rain. -)1		....
Trolley		/
Stop	Bolt	Inner
	Ring			Clevis Pin
	Fastener			5/t6"xt"
	/	Tr°llr	Y I _ii121
				Emergency
	Door			Handle
:	Bracket		oLoLo¢__St j::	dIe
	_		Door	Arm
Clevis Pin		Curved	Door Arm
5/t6°xt.i__

Figure 1

Pulley

Bolts

5/t6"-t8x7/8"

DoorBracket

Figure 2

Pulley

/4[..8" (20 cm) min...)i

%F

P / '

5%.t8x,,8.

Figure 3

25