Craftsman 139.5391 owner manual Add, Reprogram Or Change Keyless Entry PIN

To	Add, Reprogram	or Change	a Keyless	Entry PIN
NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE "LEARN"	BUTTON	USING THE PREMIUM CONTROL CONSOLE

[]

1. Press and release the "learn"

button on motor unit. The learn[] [] indicator light will glow steadily for

30 seconds.

2.Within 30 seconds enter a four digit personal identification number (PIN) of your choice on the keypad. Then press and hold the ENTER button.

3.Release the button when the

motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.

To change an existing, known PIN

if the existing PIN is known, it may be changed by one person without using a ladder.

1.Press the four buttons for the present PIN. then press and hold the # butter

The opener light will blink twice. Release the # button.

2.Press the new4-digit PIN you have chosen. Lhen press Enter.

The motor unitlightswill blink once when the PIN has _eenlearned.

Test by pressing the new PIN. then press Enter. The door should move.

To set a temporary PIN

You may authorize access by visitors or service people with a temporary 4-digit PIN. After a programmed qumber of hours or number of accesses, this temporary PIN expires and will no longer open the door. It can be used to close the door even after it has expired. To set a temporary PIN:

1.Press the four buttons for your personal entry PIN (nat the last temporary PIN), then press and hold the

butter

The opener light will blink three times. Release the button.

NOTE: This method requires two people if the Keyless Entry is already mounted outside the garage.

1.Enter a four digit personal identification number (PIN) of your

choice on the keypad. Then press and hold ENTER.

2.While holding the ENTER button,

press and hold the LIGHT button on the Premium Control Console.

3.Continue holding the ENTER and LIGHT buttons while you press the push bar on the Premium

Control Console (all three buttons are held).

4, Release buttons when the motor unit lights blink. It has learned the

code. If light bulbs are net installed, two clicks will be heard.

2.Press the temporary 4-digit PIN you have chosen, then press Enter.

The opener light will blink four times.

3.To set the number of hours this temporary PIN will work, press the number of hours (up to 255), then press _.

OR

3, To set the number of times this temporary PIN will work, press the number of times (up to 255), then press #.

The opener light will blink once when the temporary PIN has been Jearned.

Test by pressing the four buttons for the temporary PIN, then press Enter. The door should move. If the temporary PIN was set to a certain number of openings, remember that the test has used up one opening.To clear the temporary password, repeat steps 1-3, setting the number of hours or times to 0 in step 3,

36