TO INSTALL BITS

See Figure 9.

Unplug your hammer drill.

,_ WARNING: Failure to unplug your hammer drill could result in accidental starting causing serious injury.

Open or close the chuck jaws to a point where the opening is slightly larger than the drill bit you intend to use. Also, raise the front of your drill slightly to keep the drill bits from falling out of the chuck jaws.

Insert drill bit into chuck the full length of the jaws.

,_ WARNING: Do not insert drill bit into chuck jaws and tighten as shown in figure 10. This could cause drill bit to be thrown from your drill resulting in pos-

sible serious personal injury or damage to your chuck.

Tighten chuck jaws securely, using the chuck key provided. DO NOT use a wrench to tighten or loosen the chuck jaws.

Store chuck key on cord with chuck key strap.

TO REMOVE BITS

RIGHT

Fig, g

Unplug your hammer drill.

,_ WARNING: Failure to unplug your hammer drill

could result in accidental starting causing serious injury.

Loosen chuck jaws using the chuck key provided. DO NOT use a wrench to tighten or loosen the chuck jaws.

Remove drill bit from chuck jaws.

Store chuck key on cord with chuck key strap.

Fig. 10

Page10

Page 10
Image 10
Craftsman 315.10136 operating instructions To Install Bits, Right, Fig, g