1

iNDiCATOR

V SLOT

Fig. 6

Fig. 7

MOUNTING THE TABLE SAW BASE TO THE

LEG STAN D

See Figure 8.

[] Place the table saw base on the leg stand. Position the locking knob over the holes in the top of the leg stand.

[] Insert the screw on the locking knob into the hole and turn the locking knob clockwise to secure the table saw base to the leg stand.

[] Repeat with the other three locking knobs.

HOLELOCKING KNOB

Fig. 8

TO INSTALL THE HANDLE

See Figure 9.

[] Hold the nylon nut securely and turn the screw counter- clockwise to remove the nut completely. NOTE: Do not remove the screw from the handle.

[] Place the nylon nut into the recessed hole on the back of the height/bevel adjusting handwheel and hold in place.

[] Slide the handle and screw into the hole on the height/bevel adjusting handwheel.

[] Using a flathead screwdriver, turn the screw clockwise and tighten in place.

NUT

HANDLE

 

SCREW

HEIGHT/BEVEL

 

ADJUSTING HANDWHEEL

Fig. 9

 

16

Page 16
Image 16
Craftsman 315.28462 manual INDiCATOR, Slot Mounting the Table SAW Base to, Holelocking Knob