TO ASSEMBLE THE SLIDING TABLE

ASSEMLBY

See Figures 17- 18.

To install s(iding table extension:

[] Locate the sliding table assembly.

[] Unlock the front and back table locking levers.

[] Insert sliding table assembly into table locking levers.

[] Push the table assembly until it rests against the saw table and is completely closed.

[] Install phillips head screw into hole at end of the rear extension rod to hold sliding table assembly into lock- ing levers.

[] Lock the front and back table locking levers. To install indicator:

[] Locate the indicator.

[] Slip the indicator in the slot on the front rail. Fit the top

slot in the indicator over the detent on the end plug and the bottom slot over the screw hole on the end plug.

[] Insert a screw into the bottom slot of the indicator, the hole in the end plug and the extension rod. Tighten se- curely, but do not overtighten. Overtighting may crush extension rod ends.

REAR

SCREW EXTENSIONROD

%

(

SLIDING

TABLE

ASSEMBLY

Fig. 17

DETENT

_SCREWHOLE

/INDICATOR

ENDPLUG

EXTENSION

ROD

TABLE

LOCKING

LEVER

SCREW Fig. 18

20

Page 20
Image 20
Craftsman 315.28462 manual To Assemble the Sliding Table Assemlby, See Figures 17, Rear, Screw Extensionrod