Thefollowingrecommendedaccessoriesarecurrentlyavailableatretailstores:

089037008711 DadoThroatPlatewithSpecialWasher

_I_, WARNING:Currentattachmentsandaccessoriesavailableforusewiththistoolarelistedabove.Donotuse

anyattachmentsoraccessoriesnotrecommendedbythemanufacturerofthistool.Theuseofattachmentsor

accessoriesnot recommendedcanresultinseriouspersonalinjury.

PROBLEM
Excess vibration.
Rip fence does not move
smoothly.
CAUSE SOLUTION
Blade isout ofbalance.
Blade isdamaged.
Saw is not mounted securely.
Work surface is uneven.
Blade iswarped.
Rip fence not mounted correctly.
Rails are dirty or sticky.
Clamp screw is out of adjustment.
Replace blade.
Replace blade.
Tighten all hardware.
Reposition on flat surface.
Adjust legs of optional stand.
Check saw blade installation. Replace blade if
necessary.
Remount the rip fence.
Clean and wax rails.
Adjust clamp screw counterclockwise.
Rip fence does not lock at Clamp screw is out of adjustment. Adjust clamp screw clockwise.
rear.
}
Cutting binds or burns work.
Wood edges away from rip
fence when ripping.
Blade isdull.
Blade is heeling.
Work isfed too fast.
Rip fence is misaligned.
Wood iswarped.
Spreader isout of alignment.
Blade not properly sharpened or set.
Replace or sharpen blade.
See page 29 on "Heeling the Blade".
Slow the feed rate.
Align the rip fence.
Replace the wood. Always cut with convex
side to table surface.
See "Tocheck andalign the spreader/riving knife
and saw blade" in the Assembly section.
Resharpen or set blade.
39