Set Screws
Latches
Figure 36 - Latches Lock and Unlock Blade Guard and Pawls to Riving knife
INSTALL MITER GAUGE
Refer to Figure 37.
¥The miter gauge comes preassembled. Unpack the miter gauge and clean thoroughly. Insert into storage slots on right side of cabinet.
Figure 37
INSTALL PUSH STICK
Refer to Figure 38.
¥Insert the push stick into brackets on left side of base.
Figure 38
INSTALL RIP FENCE
Refer to Figure 39.
¥Position rip fence assembly at end of saw. Be certain lock- ing lever is in UP unlocked position.
¥Place rip fence assembly onto rails, positioning clamp over rear rail and then placing rip fence onto front guide rail.
¥Rip fence should now ride freely on rip fence rails. Once rip fence is completely installed, it should be parallel with the miter gauge and perpendicular to the table. If not, refer to ÒRip Fence AdjustmentÓ in the Operation section of this manual.
Figure 39
INSTALLATION
GROUNDING INSTRUCTIONS
WARNING: Improper connection of equipment grounding con- ductor can result in the risk of electrical shock. Equipment should be grounded while in use to protect operator from electrical shock.
¥Check with a qualified electrician if grounding instructions are not understood or if in doubt as to whether the tool is properly grounded.
¥This tool is equipped with an approved
¥Grounding plug should be plugged directly into a properly installed and grounded
Properly Grounded Outlet
Grounding Prong
Figure 40 - 3-Prong Receptacle
¥Do not remove or alter grounding prong in any manner. In the event of a malfunction or breakdown, grounding pro- vides a path of least resistance for electrical shock.
WARNING: Do not permit fingers to touch the terminals of plug when installing or removing from outlet.
¥Plug must be plugged into matching outlet that is properly installed and grounded in accordance with all local codes and ordinances. Do not modify plug provided. If it will not fit in outlet, have proper outlet installed by a qualified electrician.
13
