ATTACH CORD WRAP HOOKS
Refer to Figure 13.
Tools Required: 4mm Hex Wrench
Hardware Required: Two M6 x 16 socket pan head bolts, two M6 flat washers and two M6 hex nuts (Hardware bag #4).
¥Insert a bolt into a cord wrap hook and place against the holes on the left side of the saw cabinet.
¥Secure hook in position using flat washer and hex nut.
¥Repeat for other hook.
Figure 13
ATTACH BASE TO CABINET
Refer to Figures 14 and 15.
Tools Required: 8mm Hex Wrench
Hardware Required: Four M10 x 25 socket head bolts, four M10 lock washers and four M10 flat washers (Hardware bag #4).
¥Place dust chute over the cabinet as shown. Make sure the holes in the corners are aligned with the slots in the dust chute.
Figure 14
¥Place the base assembly over the dust chute and secure the base assembly to the cabinet using the flat washers, lock washers and bolts.
¥Secure all fasteners in the base assembly fully tight.
Figure 15
ATTACH RIP FENCE BRACKETS
Refer to Figure 16.
Tools Required: 5mm Hex Wrench
Hardware Required: Two M6 x 16 socket head bolts, two M6 flat washers and two M6 hex nuts (Hardware bag #4).
¥Install the rip fence storage brackets to the right side panel of the base using two bolts, flat washers and hex nuts.
Figure 16
BLADE GUARD AND PUSH STICK STORAGE BRACKETS
Refer to Figure 17, page 9.
Tools Required: Phillips screwdriver and 4mm hex wrench
Hardware Required: Four M3 x 10 pan head screws, four M3 lock washers, four M3 flat washers, four M5 x 12 socket head bolts, four M5 lock washers and four M5 flat washers (Hardware bag #4).
¥Install the push stick storage brackets to the left side panel of the base using four screws, lock washers and flat washers.
¥Install the blade guard storage brackets to the left side panel of the base using four screws, lock washers and flat washers.
NOTE: Attach the slotted bracket to the front side of the saw.
¥Press the four rubber feet to the base legs.
¥With the aid of an assistant turn the saw upright. WARNING: To avoid injury, Do Not attempt to turn saw upright by yourself.
8
