ICRAFTSMAN°I

CHEST TOP WITHOUT TASK LIGHT

Tools Required:

Screwdriver, Crosstip

Chest

top

removal

 

 

 

 

 

Chest

top

installation

 

 

 

 

 

 

 

Disconnect

power

 

from

unit.

 

Position

top

on

unit.

Attach

using

(4)

Remove

pull

out

work

surface.

(See

screws.

 

 

 

 

 

 

 

 

 

 

 

drawer

installation

 

and

removal.)

Position

lock in

unit.

Install

retaining

 

Remove

enough

drawers

to

reach the

clip

to

hold

lock

in place.

 

 

 

 

 

 

top

back

inside of

the

unit.

(See

Make

sure

the back

of the

lock rod

is

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Drawer

installation

 

and

removal.)

inserted

into the

lock

rod

 

holder

in

the

Remove

lock retaining

clip.

Pull

lock

back

of the

unit.

 

 

 

 

 

 

 

 

 

out

to remove.

 

 

 

 

 

Push

 

the

lock rod

toward

 

the

back

of

Remove

(4)

screws

holding

top

in

unit

the and

line

up with

lock.

Insert

 

 

place.

 

 

 

 

 

 

 

 

the lock rod into the back of the lock.

Remove

top

from

 

unit.

 

 

 

Test

lock

operation.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Reinstall

drawers.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Reconnect

 

power

to

the

unit.

 

 

 

Lock

Lock

retaining clip

Lock

 

Remove

 

 

holder

Lock rod

screws

DRAWERINSTALLATION AND REMOVAL

Empty the drawer.

Fully extend the drawer.

Release

Lever Style - Lift or lower (depending on the slide) the release lever on both sides, (this allows the slides to ride

over the stops.) Pull out to remove.

Tab Style - Depress the release tabs on both

sides, (this allows the slides to ride over the

stops.) Pull out to remove.

To reinstall, carefully align the slides and push the drawer into the unit until the drawer stops.

Sears, Roebuck and Co., Hoffman Estates, IL 60179, USA

F1616

2

 

Page 11
Image 11
Craftsman 706.59668, 706.59669 owner manual Chest TOP Without Task Light, Lock Retaining clip, Holder Lock rod, Installation