BEFOREOPERATING SNOW THROWER
Checkthefasteners.Makesureall fastenersare tight.
Readthis OPERATOR'SMANUALand OPERATORSAFETYbefore
operatingyoursnowthrower. Comparethe illustrationswithyour
SNOWTHROWERtofamiliarize yourselfwith the locationofvar- iouscontrolsandadjustments. Savethis manual for future refer-
once.
OPERATION
NOTE: This snow thrower was shipped WiTH OiL in the engine. See "Before Starting Engine" instructions in the OPERATIONsection of this manual before starting engine.
WARNING:The operation of any snow thrower can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields beforebeginningsnow thrower operation. We recommend
standard safety glasses or Wide Vision Safety Mask over spectacles.
OPERATETHE SNOWTHROWER
Themosteffectiveuseof thesnowthrowerwill beestablishedbyexperi- ence,takinginto considerationtheterrain,windconditions,andbuilding locationwhichwill determinethedirectionof thedischargechute.
NOTICE:Do not throwsnowtoward a buildingas hiddenobjects could be thrownwith sufficient force to causedamage.
1.StarttheengineSee"ToStartEngine".inthis section.
2.Rotatethecrank(A, Figure12)to setthedirection(leftor right)of the dischargechute.
3.AdjustthesnowchutedeflectorLoosenthewingnut. (A,Figure14)on thesideof thesnowchuteandraisethechutedeflectorfor more
distance,or lowerit for lessdistanceThentightenthewing. nut.
5.Engagetheaugerdriveclutchlever(A,Figure15).
DOWN EngagePosition
UP DisengagePosition
6.Engagethetractiondriveclutchlever(B).Asthesnowthrowerstarts to move,maintainafirm holdonthehandlesandguidethesnow
throweralongthecuttingpath.Donotattemptto pushthesnow thrower.
7.Tostopforwardmotion,releasethetractiondriveclutchlever(B).
Adjust ChuteDeflector | Figure 14 | |
_ | AUTION:Before operating, | make sure the area in front |
| of the snow thrower is clear of bystandersor obstacles. |
NOTE:Always release the tractioncontrol lever beforemoving the speed select lever.
4.Usethespeedselectlever(A, Figure12)to selecttheforwarddrive speed.Setthespeedselectleverto oneof thefollowingpositionsas determinedby snowconditions:
3 Moderate
6 Transport
NOTE:When clearing wet, heavy, snow, it is recommended that the ground speed of the unit be reduced, maintain full throttle, and do not attempt to clear the full width of the unit.
,)',
",,j
CiL2
\\//
Control Levers | Figure15 |
8.Tostoptheauger,releasetheaugerdriveclutchlever(A).
9.Tomovethesnowthrowerbackwards,movethespeedselectlever(A,Fig- ure12)intofirstorsecondreverse(R1orR2),andengagethetractiondrive clutchlever(B,Figure15).
_ | WARNING:Never run engine indoorsor in an enclosed, |
| poor ventilated area. Engine exhaust containsCARBON |
| MONOXIDE,an ODORLESSand DEADLYGAS. |
,,Keep hands, feet, hair, and loose clothing away from any moving parts on engine and snow thrower.
,,Temperatureof muffler and nearby areas can exceed 150°F (66°C). Avoid these areas.
,,DONOTallow children or youngteenagers to operate or be near snow thrower while it is operating.
17