Crane Merchandising Systems 673 Monetary Setup HDC II Programming Guide, Bill Selection Method

SELECT BILL VALIDATOR

Monetary Setup HDC II Programming Guide

1.	Press	, then press	until one of the following is displayed:
		- No bills will be accepted or there is no bill validator
		installed (you can exit the function).
		- The pulse bill validator will accept $1 bills.
		- The serial bill validator is selected and will accept $1, $2,
		$5, $10, and $20 bills. Use BILL SELECTION METHOD
		below to change the bills that will be accepted.
		- A standard MDB bill validator is selected. It will accept
		$1, $2, $5, $10 and $20 bills. Use BILL SELECTION
		METHOD below to change the bills that will be accepted.
		BILL SELECTION METHOD:
		The standard $1, $2, $5, $10 and $20 bills are enabled by
		pressing the 1, 2, 5, 6, or 7 key(s), respectively, to display
		which bill(s) will be accepted.
	<*>	- An MDB bill validator that accepts coupons or non-stan-
NODBV		dard bills (normally used for non-U.S. currency) is con-
		nected and operating. Press		to enter list of bills.
		See BILL LIST OPERATION. See INITIAL SETUP OF
		NON-STANDARD BILL VALIDATOR.
2.	Press	to choose the desired option.
mripb=as
SER.1.2.5.10.203. Proceed to "Select Monetary Options", PAGE 15, to customize your bill
	validator choice.
			NOTE
MDB.1.2.5.10.20Depending upon your choice of bill validator, some choices
MDB.4. CONTINUE.			may not display.

6730018 13 July, 2003