Crane Merchandising Systems 673, 677, 675 manual Messages HDC II Programming Guide, Shortcut

EDIT CUSTOM MESSAGE

Messages HDC II Programming Guide

4. When the character you want to change is flashing, either enter it directly,

1.	Press	, then press	until the display shows		' . Press
	the number of the message you want to edit.				is displayed (X
	represents the message number you pressed).
			NOTE
	Custom message 8 represents the			message.
2.	Press	. The message text is displayed with the first character
	flashing.
3.	To view the message, press		. The message scrolls across the
	display. To stop the scrolling, press			INSERT.=jbpp^db=uMUG

or use and to step through the character set until the desired

character is displayed. Use the arrow keys to highlight different charac-
ters. See the section on the next page for an explanation ofbafq=jpdspecial keysp			and
the character set.
	SHORTCUT
Instead of stepping through the whole character set to enter a letter
that is not on your keypad, enter one close to the one you want, then
step to it. Example: If you want to enter an L, first press		,
	six times. Your L should now be displayed.
then press

THE END OF MESSAGE CHARACTER

This is the most important character in your message, because it tells the machine when the message is ended. If you don't use this character, your message will be followed by a bunch of zeros. This character can be selected either from the character set or by a direct key entry (see "ENTERING YOUR MESSAGE", PAGE 50).

6730018 49 July, 2003