Creda C561E/R561E manual Ceramic Hob General Information, Rear left twin circuit plate

Ceramic Hob General Information

CAUTION: IF ANY CRACK IN THE SURFACE BECOMES VISIBLE, ISOLATE FROM THE MAINS SUPPLY. DO NOT USE THE COOKER.

Under no circumstances should the hob be used with aluminium foil in contact with the hob surface. The following boiling plates are located beneath the circular cooking areas:-

	C561 / R561E
Front	Single circuit 1800W Solarglo
Right
Rear	Twin circuit 1500W Solarglo
Left	single (inner) circuit 850W
Rear	Single circuit 1200W Solarglo
Right
Front	Single circuit 1200W Solarglo
Left

The cooking areas change colour when heated (become red) indicating which heating element is turned on. The cooking area returns to its original colour when the heating element is switched OFF and cools.

Rear left twin circuit plate

This is a dual purpose plate with two elements. The settings on the control knob will show 1 - 4 when the control is turned clockwise to indicate that the whole hotplate is turned on and can be used for larger pans, 4 is the highest setting. With the control knob turned anti- clockwise the settings on the control knob will show 1 - 4 to indicate that only the inner part of the hotplate is switched on.This is an energy saving feature and is useful for cooking with smaller pans or for slow simmering.The control will be OFF when the control knob is turned to the O position.

Front left – Front right – Rear right –plates

When the control is turned from the 0 position, the settings on the control knob will show 1 - 6.

6 is the highest setting, for fast cooking. To reduce the heat to cook more slowly or simmer, turn the knob to a lower setting which will vary according to size and type of saucepan, the amount and type of food, and whether or not a lid is fitted. Pans can be placed on the unheated areas of the panel when cooking is finished and before serving food.

It is inadvisable at any time to leave a heating element switched on without a pan in position as this wastes energy, and could make soil or rub-off from aluminium pans more difficult to remove. To protect elements against overheating, safety cut-outs have been incorporated with each element. After several minutes with the control at setting 6 (setting 4 on twin circuit plate) the safety cut-out switches the element Off and On continuously, thus preventing any adverse effects that may be caused by an excessive build-up of heat in the cooking area.

Setting 1 provides very low inputs of 3% to 10% for low simmering. (Excluding the twin circuit plate). The control will be Off when the control knob is turned to the O position.

If hob should become cracked, never use the cooker until the hob has been repaired.

17