Crestron CEN-CN | Ethernet/Cresnet Interface |
and list it in the dialog box. Modify or delete existing entries or add new ones. When all the necessary changes have been made, save the new table to disk and/or load it back into the unit. Do not overwrite the IP table in the CEN-CN the next time the program is uploaded, unless the addresses in the program supercede those in the current IP table.
NOTE: For more detailed information, refer to the SIMPL Windows help file by selecting Help Help Topics. Select the Index tab, type in IP table, then select Changing IP Addresses without Changing the Program.
Crestron e-control™ IP Table Information
It is extremely important that the IP ID in the SIMPL Windows program match the
IP ID (sometimes called the Cres ID) in the IP Table of the CEN-CN.
Hookup Diagram for Normal Operation
When operating the CEN-CN under normal conditions, refer to figure on the next page for a typical connection diagram. Other than making the power connection last, complete the connections in any order.
CAUTION: When the ETHERNET port is connected to a larger network via a hub, make sure that a straight (non-crossover type) Ethernet cable is used and that the cable is NOT connected to the UPLINK port of an Ethernet hub. The cable is not provided.
CAUTION: If making connections to the RJ11 NET modular port, use the Crestron 6-conductor modular cable provided, DO NOT use 6-conductor telephone cables. Telephone cables are wired in a crisscross fashion and are not compatible with Crestron equipment. For further information, refer to the latest revision of Modular Cable Requirements (Doc. 5682). This document can be obtained from the Downloads page (CABLES and MANUAL Libraries) of Crestron’s website (www.crestron.com). Search for MODULAR.PDF. New users are required to register in order to obtain access to the FTP site.
CAUTION: If making connections to the CEN-CN Cresnet peripherals from the
NET 4-wire ports, refer to “Cresnet Wiring” on page 5.
NOTE: Operating power for the CEN-CN may be supplied either by the external AC power pack (included) that provides 12VDC or supplied by 24VDC via the 4-wire CEN-CN Cresnet system wiring.
NOTE: The RJ11 NET modular port provides +24VDC only if power is supplied via Cresnet wiring connected to the 4-wire NET port(s). The external AC power pack does not supply power to this port.
