CLEANING AND MAINTENANCE
Always unplug your Cuisinart® SmartPower® Portable Compact Blender from the electrical outlet before cleaning. The base and parts are made of
To remove blade assemblies, twist off by turning counterclockwise.
NEVER TOUCH THE BLADE ITSELF.
CAUTION: Handle the blade assemblies carefully. They are SHARP and may cause injury. DO NOT attempt to remove blades from cutting assembly.
Wash all parts in warm, soapy water; rinse and dry thoroughly. All parts are top rack dishwasher safe.
Tip: You may wish to clean your blending and chopper cutting assemblies
as follows: squirt a small amount of dishwashing liquid into blender jar or cups and fill halfway with warm water. Attach blade assembly. Run on Low for 15 seconds. Repeat, using clean tap water. Carefully disassemble parts and empty blender jar or cups. Rinse and dry all parts thoroughly.
Finally, wipe the motor base clean with a damp cloth to remove any residue, and dry thoroughly. Never submerge the motor base in water or other liquids, or place in a dishwasher.
Any other servicing should be performed by an authorized service representative.
Troubleshooting
Problem: |
| Solution: | |
|
| ||
| Be sure the blade assembly is on the jar or cup correctly. | ||
| Be sure it is pushed all the way onto the base. A red light | ||
| should come on and the unit should be in Standby mode. | ||
My blender is not turning | 1. | Plug blender into an independent outlet. | |
on or going into Standby | 2. | Make sure blender is securely plugged in. | |
mode? |
| as stated on page 5. | |
| 3. | Check the outlet for power; try plugging into a different | |
|
| outlet. | |
| 4. | Check your home's circuit breaker. | |
|
| ||
| The motor could have overheated. The resettable fuse, | ||
| which protects the motor due to overloading, may have | ||
The blender stopped | been tripped. When this happens, to reset the appliance | ||
unplug the unit and let it cool for a minimum of 15 minutes. | |||
running. | |||
Then, reduce the contents of the blender jar and/or clear | |||
| |||
| any jams. Restart the unit as noted in the operating | ||
| directions. | ||
|
|
| |
The rubber gasket won’t | Run under water and tap on the edge of sink upside down | ||
come out from the blade | |||
to loosen the gasket. | |||
assembly for cleaning. | |||
|
| ||
|
| ||
The blade assembly is | The ingredients cause pressure, and with the air tight seal, | ||
hard to remove after | pressure builds up creating a vacuum or a suction effect. | ||
blending. | This is normal. | ||
|
|
| |
| 1. | Check rubber gasket. Make sure it's flush with blender | |
Unit appears to be leaking |
| assembly. | |
2. | Make sure rubber gasket is properly in place. | ||
| |||
| 3. | Make sure rubber gasket is not damaged. | |
|
|
|
6