Problem Solving
If after pressing the Talk button, you receive three “beeps” and no dial tone, check the following:
1.BASE UNIT is plugged into a power source.
2.If you had a power failure or had unplugged the BASE UNIT, replace the HANDSET on the BASE UNIT for 2 to 5 seconds to reset the system.
NOTE:
If none of the telephones in the house are working, disconnect one set at a time to verify that none of the phones are causing the problem. If you still have a problem after doing this, and your telephone still does not work, please contact your local phone company.
Can not register the HANDSET, when place HANDSET to BASE UNIT not a long beep heard but the triple beep, check as following:.
1.HANDSET is more than 5.
2.Already has a HANDSET with ID=5, and wish register a new one. In this situation, you should reset the BASE UNIT.
3.reset the BASE UNIT: In standby mode, plug the T/P switch to the “P” position and push and hold the PAGE button on the BASE UNIT 8
