CyberData VoIP Intercom 2.2.6 RTFM Switch Jumper, 2.2.6.1 Announcing the IP Address, Note, Note, Call, (RTFM), Figure 2-11.RTFM Switch Jumper

Installing the VoIP Intercom 13

Intercom Setup

2.2.6 RTFM Switch Jumper

When the Intercom is operational and linked to the network, use the Reset Test Function Management (RTFM) switch (see Figure 2-11) on the Intercom board to announce and confirm the Intercom’s IP Address, test that the audio is working, and check the volume.

Note You must do this test prior to final assembly. Please remember to remove the RTFM switch jumper prior to final assembly.

Figure 2-11. RTFM Switch Jumper

2.2.6.1 Announcing the IP Address

To announce an Intercom’s current IP address:

1.Unplug the intercom.

2.Install the RTFM jumper.

3.Plug the network cable into the intercom to supply power to the intercom. The LED will illuminate during initialization, blink once, and then turn off.

4.The intercom will announce the IP address.

Note If you installed the RTFM jumper, and if you press the Call button for 10 seconds, the default factory settings will be restored.

Operations Guide 930181B CyberData Corporation