14Installing the VoIP Intercom Intercom Setup

2.2.6.2 Restoring the Factory Default Settings

To restore the factory default settings:

1.Complete the steps in Section 2.2.6.1, "Announcing the IP Address".

2.Press and hold the Call button for 10 seconds.

3.When you hear the announcement, release the Call button. The factory default settings are restored, and the intercom will automatically restart.

2.2.6.3Restore the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a known state.

Each Intercom is delivered with factory set default values for the parameters indicated in Table 2-3. Use the RTFM switch on the Intercom face to restore these parameters to the factory default settings.

Note When you use the RTFM switch, the factory default settings are restored for only the parameters indicated in Table 2-3. The other parameters in the current Intercom configuration will remain unchanged.

 

Table 2-3. Factory Default Settings

 

 

Parameter

Factory Default Setting

 

 

IP Addressing

static

 

 

IP Address

192.168.3.10

 

 

Web Access Username

admin

 

 

Web Access Password

admin

 

 

Subnet Mask

255.255.255.0

 

 

To restore these parameters to the factory default settings:

CyberData Corporation

930181B

Operations Guide