Cypress STK11C88 Hardware Protect, Noise Considerations, Low Average Active Power, Best Practices

STK11C88

Hardware Protect Figure 3. Icc (max) Writes

The STK11C88 offers hardware protection against inadvertent STORE operation and SRAM WRITEs during low voltage conditions. When VCC<VSWITCH, all externally initiated STORE operations and SRAM WRITEs are inhibited.

Noise Considerations

The STK11C88 is a high speed memory. It must have a high frequency bypass capacitor of approximately 0.1 µF connected between VCC and VSS, using leads and traces that are as short as possible. As with all high speed CMOS ICs, careful routing of power, ground, and signals help prevent noise problems.

Low Average Active Power

CMOS technology provides the STK11C88 the benefit of drawing significantly less current when it is cycled at times longer than 50 ns. Figure 2 and Figure 3 show the relationship between ICC and READ or WRITE cycle time. Worst case current consumption is shown for both CMOS and TTL input levels (commercial temperature range, VCC = 5.5V, 100 percent duty cycle on chip enable). Only standby current is drawn when the chip is disabled. The overall average current drawn by the STK11C88 depends on the following items:

1.The duty cycle of chip enable

2.The overall cycle rate for accesses

3.The ratio of READs to WRITEs

4.CMOS versus TTL input levels

5.The operating temperature

6.The VCC level

7.IO loading

Figure 2. Icc (max) Reads

Best Practices

nvSRAM products have been used effectively for over 15 years. While ease-of-use is one of the product’s main system values, the experience gained working with hundreds of appli- cations has resulted in the following suggestions as best practices:

■The nonvolatile cells in a nvSRAM are programmed on the test floor during final test and quality assurance. Incoming inspection routines at customer or contract manufacturer’s sites, sometimes, reprogram these values. Final NV patterns are typically repeating patterns of AA, 55, 00, FF, A5, or 5A. The end product’s firmware should not assume that a NV array is in a set programmed state. Routines that check memory content values to determine first time system config- uration and cold or warm boot status, should always program a unique NV pattern (for example, a complex 4-byte pattern of 46 E6 49 53 hex or more random bytes) as part of the final system manufacturing test to ensure these system routines work consistently.

■Power up boot firmware routines should rewrite the nvSRAM into the desired state. While the nvSRAM is shipped in a preset state, best practice is to again rewrite the nvSRAM into the desired state as a safeguard against events that might flip the bit inadvertently (program bugs or incoming inspection routines).

Document Number: 001-50591 Rev. ** Page 4 of 15

[+] Feedback