D-Link DES-3224 Snmp Trap Manager Setting, Cold Start, Authentication Failure, Link Change Event

10/100 Auto Negotiation Switch User’s Guide

SNMP Trap Manager Setting

Enables you to enter the IP addresses of Trap Managers. Traps are messages the DES-3224 sends out to inform trap managers of events on the network. The DES-3224 generates traps and sends them to the network manager. Trap managers are special network users who are given certain rights and access to oversee and maintain the network. This feature is available only in D-View or by using other SNMP management software.

You can specify which network managers may receive traps from the DES-3224 by creating a list of IP Addresses of the authorized network managers.

Trap managers can receive the following trap types:

∙Cold Start

∙Authentication Failure

∙Link Change Event

Cold Start

Signifies that the DES-3224 has been powered up. Software settings are reconfigured and hardware systems are rebooted. A cold start is different from a factory reset.

Authentication Failure

Signifies that an addressee (or manager/ user) on the DES-3224 is not a valid user of the DES-3224 and may have entered an incorrect community name.

Link Change Event

Signifies that the link of a port has changed from link up to link down or vice versa.

IP Address

This field is used to enter the IP Addresses of Trap Managers.

SNMP Community String

Enter the Community String of the Trap Mangers in this field.

Status

The DES-3224 will not send out traps unless the status is Valid.

Follow these steps to enter the SNMP Community String:

1.Enter the name of the SNMP Community.

2.Select the Access Right field and toggle the space bar to select Read Only or Read/ Write.

3.Select the Status field and toggle the space bar to select Valid or Invalid.

4.Select Save and press Enter.

Managing the DES-3224 45