Power On | D-Link DES-5016 manual

Fast Ethernet Switching System User’s Guide

Power On

The power supply will adjust to the local power source automatically. The DES-5016 may be plugged in without having any or with all LAN segment cables connected.

The power plug is located at the rear of the DES-5016. Plug the cable into the wall socket and plug the other end into the DES-5016. There is a power on/ off switch located at the rear of the DES-5016. Move the switch to the on position to power the DES-5016 on. The Power LED will light and all ports will auto negotiate the proper speed and duplex mode when the DES-5016 is powered on.

Reboot the DES-5016 if there is a problem. Contact D-Link Systems, Inc. for technical support.

Check the configuration of the DES-5016 after a power failure but do not reset unless it is necessary.

The DES-5016 can be used with power sources in the range 100 to 240 VAC., 50 to 60 Hz.

Installing the DES-5016

17

Image 25

D-Link DES-5016 manual Power On

Contents

DES-5016 Fast Ethernet Switching System User’s Guide Software Link Limited Warranty Hardware North, Central, and South America Link Offices for Registration and Warranty ServiceEurope and Israel Copyright Statement Wichtige Sicherheitshinweise Table of Contents Page Page Audience About This GuideOrganization Introduction FeaturesPage DES-5016TX Front Panel DES-5016TF DES-5016TF DES-5016 Rear Panel Rear Panel Updating Firmware Management MethodsLocal Console Management Telnet Management Unpacking the DES-5016 Installing the DES-5016 Installation Options Install Feet on Bottom Desktop/ Shelf Installation Attach Feet Attach Mounting Brackets Rack Installation Insert into Rack Installing Optional Modules Remove Blank Bracket Insert Optional Module Power On Cable Specifications Connecting the DES-5016 to the NetworkCopper Cable Cable Diagram Fiber Optic Cable MDI-X Ports PortsFiber Optic Ports RS-232 Port DES-5016 to DES-5016 Connection Connecting the DES-5016 to other Switches and Hubs DES-5016TF LEDs LEDs Diagnostic PowerCPU Module Status LED Link Port TX ModuleAct 100/10 Port TX Module LEDs Link/ Act Port FX Module Col Port 100BASE-FX Module Lit Dark Gigabit Module LED Port 1000BASE-SX Module Managing the DES-5016 ∙ Data bits ∙ Parity None ∙ Stop bits ∙ Flow Control None Local Console Management Telnet Log ∙ Default User Name D-Link ∙ Default Password D-Link Help Message Help Message Spacebar Panel Conventions Switch Port 1-8, 9-16 and Optional Module Configuration System Configuration100BASE-FX/ 1000BASE-SX Switch Port Module Console Program Snmp Management Configuration Spanning Tree ConfigurationVlan Port Management Trunking Port Management System Reset System Configuration MenuFactory Reset to Default Config Values System Information Boot Prom Firmware Version Software UpdateSystem Information Menu Hardware Revision MAC Address LAN Default GatewaySystem Description System Name System Reset System Reset Factory Reset Factory Reset Factory Reset Confirmation Advantages of Store and Forward System Rate ControlDisadvantages of Store and Forward Disadvantages of Cut-Through Advantages of Cut-Through Software Update menu Software Update Menu Transfer Firmware Xmodem User Account Change Menu User Account Management Confirm Password PasswordAccess Level Create New UserPage Status Delete UsersDelete Page Old Password Change PasswordNew Password Page Switch Port Configuration State Switch Port Configuration MenuPhysical Priority Port StateFlow Control Spanning Tree Configuration Menu Spanning Tree ConfigurationSTA Operation Levels Spanning Tree Algorithm Forward Delay TimeBridge Priority Root Cost Root Port Root Bridge Snmp Management Configuration Snmp Manager Setting Snmp Management Configuration MenuAccess Right Snmp Community String Authentication Failure Snmp Trap Manager SettingCold Start Link Change EventPage Vlan Port Management Vlan Port Management menu Vlan Port Management Menu New Vlan Name Create New VlanPort # TrunkGroupPage Vlan Name Delete Vlan Menu Virtual LAN Name Modify Vlan Menu Trunking Port Management menu Trunking Port Management Menu New Trunking Group Name Create New Trunking PortName Page Trunking Port Delete Trunking PortModify Trunking Port Modify Trunking Port Trunking Port Name Problem Solution Post Errors TroubleshootingCables Port StatesPage Diagnostic LED Switch Specifications Appendix a DES-5016 Technical SpecificationsPort Specifications Page Fast Ethernet Switching System User’s Guide General EMI Fast Ethernet Switching System User’s Guide Performance Act Index User Name 52, 54