Dacor EF48DBSS Replacing the Water Filter, Flushing the Water System After Replacing Filter

Models: EF42NBSS EF48DBSS IF42NBOL IF48DBOL EF48NBSS IF48NBOL

1 24
Download 24 pages 56.35 Kb
Page 16
Image 16
Replacing the Water Filter

Care and Cleaning

Replacing the Water Filter

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

1.Locate the water filter cap in the front base grille. Rotate the cap counterclockwise to a vertical position and pull the cap and filter cartridge out through the base grille.

NOTE: There will be water in the filter. Some spilling may occur.

2.Remove the cap by sliding it off the end of the used filter. The cap will slide to the left or right.

IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter.

3.Take the new water filter out of its packaging and remove the protective cover from the O-rings. Discard the protective cover.

4.Slide the cap (removed in Step 2) onto the new filter. See illustration in Step 2.

5.With cap in the vertical position, push the new water filter into the base grille until it stops. Rotate the cap clockwise to a horizontal position. Flush the water system. See Flushing the Water System After Replacing Filter.

Flushing the Water System After Replacing Filter

Use a sturdy container to depress the water dispenser bar until the water begins to flow. Flush the water system by dispensing and discarding 6 qt (5.7 L) of water. Cleaning the system will take approximately 3 to 4 minutes and will help clear air from the line. Additional flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of the dispenser. WATER FILTER

CERTIFICATIONS

Using the Dispenser Without the Water Filter

You can run the dispenser without a water filter. Your water will not be filtered.

1.Remove the water filter.

2.Slide the cap off the end of the filter.

3.With the cap in the vertical position, insert the cap into the base grille until it stops.

IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter.

4.Rotate the cap to a horizontal position. The cap might not be even with the base grille.

14

Page 16
Image 16
Dacor EF48DBSS, IF48NBOL Replacing the Water Filter, Flushing the Water System After Replacing Filter, Care and Cleaning