Refrigerator Operation
To Remove and Replace the Ice Bin (non-dispensing models):
1. Flip up the ice maker cover.
A 
B 
A. Ice maker cover
B. Ice bin
2.Lift the wire shutoff arm so it clicks into the off (up) position. Ice can still be dispensed, but no more can be made.
3.Lift up the front of the storage bin and pull the ice bin forward.
4.Replace the bin by pushing it in all the way or the dispenser will not work. Push the wire shutoff arm down to the on position to restart ice production. Make sure the door is closed tightly.
Dispensing Models
To Turn the Ice Maker On/Off:
1.The On/Off switch is located on the top right side of the freezer compartment.
Ice Maker
2.To turn the ice maker on, slide the control to the ON (left) position.
NOTE: Your ice maker has an automatic shutoff. The ice maker sensors will automatically stop ice production, but the control will remain in the ON (left) position.
3.To manually turn the ice maker off, slide the control to the OFF (right) position.
To Remove and Replace the Ice Storage Bin (dispensing models):
1.Hold the base of the storage bin (located on the back of the freezer door) with both hands and press the release button to lift the storage bin up and out.
NOTE: It is not necessary to turn the ice maker control to the OFF (right) position when removing the storage bin. The sensor cover (“flipper door”) on the left wall of the freezer stops the ice maker from producing ice if the door is open or the storage bin is removed.
2.Replace the storage bin on the door and push down to make sure it is securely in place.
Clean the Ice Storage Bin
1.Empty the ice container. Use warm water to melt the ice if necessary.
NOTE: Do not use anything sharp to break up the ice in the bin or bucket. This can cause damage to the ice container and the dispenser mechanism.
2.Wash ice bin with a mild detergent, rinse well and dry thoroughly. Do not use harsh or abrasive cleaners or solvents.
IMPORTANT:
Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill ice container. Discard the first three batches of ice produced to avoid impurities that may be flushed out of the system.
The quality of your ice will be only as good as the quality of the water supplied to your ice maker.
Avoid connecting the ice maker to a softened water supply.
Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.
It is normal for the ice cubes to be attached at the corners. They will break apart easily.
For
Do not store anything on top of the ice maker or in the ice storage bin/bucket.
9
