Daewoo KOG-371H0S, KOG-373R0S, KOG-374R0S, KOG-375R0S Remove the gasket door from door plate

1)Remove the gasket door from door plate.

2)Remove a screw which secure the door plate and door frame.

3)Remove the door frame from door plate.

4)Remove the stopper hinge top from door plate.

5)Remove the spring and the hook.

6)Remove the supporter barrier screen outer from door frame.

7)Remove the barrier screen outer from door frame.

8)Remove the decorater door rrom door frame.

9)Reverse the above steps for reassembly.

4.Method to reduce the gap between the door seal and the oven front surface.

1)To reduce gap located on part ‘A’.

•Loosen a screw on stopper hinge top, and then push the door to contact the door seal to oven front surface.

•Tighten a screw.

2)To reduce gap located on part ‘B’.

•Loosen two screws on stopper hinge under, and then push the door to contact the door seal to oven front surface.

•Tighten two screws.

NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm2.

26