Daewoo KOG-373R0S PRINTED CIRCUIT BOARD KOG-371G/H0S, KOG-391G/H0S, Circuit Check Procedure

PRINTED CIRCUIT BOARD <KOG-371G/H0S, KOG-391G/H0S>

1. CIRCUIT CHECK PROCEDURE

1.Low voltage transformer check

The low voltage transformer is located on the P.C.B. Measuring condition: Input voltage: 230V / Frequency: 50Hz

Terminal Voltage	LOAD	NO LOAD
4-7	AC 25.8 V	AC 28.4 V

NOTE

1.Refer to Ciruit Diagram (point 4).

2.Secondary side voltage of the low voltage transformer changes in proportion to fluctuation of power source voltage.

3.The allowable tolerance of the secondary voltage is within ± 5% of nominal voltage.

2.Voltage Check - Key check point

NO	CHECK POINT	REMARK
1	IC1 PIN 2, 21, 30, 34	-5VDC
2	IC1 PIN 35

T : 20ms(50Hz)

3

IC1 PIN 31 OR 32

T : 250 ns(4MHz)

- Check method

NO	MEASURE POINT	WAVE FORM	REMEDY	REMARK
1	MP1	DC -5V±0.25V	Replace VL1, EC1	NO LOAD
2	MP2	DC -12V±2.0V	Replace EC2, D12,13,14	NO LOAD

NOTE

Each measure point must be measured with GND points.

54