(TROUBLE 4) The following visual conditions indicate a probable defective touch control circuit or membrane switch assembly.
11. Incomplete segments
(1)Segments missing
(2)Partical segments missing
(3)Digit flickering other than normal display slight flickering
(4)
:0 
does not display when power is on.
12. A distinct change in the display are not on when they numbers is the display.
13. One or more digits in the display are not on when they should be.
14. Display indicates a number different from one touched.
15. Specific numbers (for example 2 or 3) will not display when the panel is touched.
16. Display does not count down or up with time cooking or clock operation.
17. Oven is programable and cooks normally but no display shows.
18. Display obviously jumps in time while counting down.
19. Display counts down noticeably too fast while cooking.
10.Display does not show the time of day when STOP/CLEAR pad is touched.
11.Oven lamp and turntable motor do not stop although cooking is finished. Check if the RELAY 2 contacts close if they are close, replace touch control circuit.
CONDITION | CHECK | RESULT | CAUSE | REMEDY |
Display does | Check each pad for | Normal | Malfunction | Replace |
| ||||
not show | continuity of the membrane |
| of control circuit | control circuit |
programming | keyboard for the following key- |
| board | board |
at all, even if | board check procedure |
|
|
|
keyboard is |
|
|
|
|
touched. |
|
|
|
|
|
| Abnormal | Malfunction | Replace the |
|
|
| ||
|
|
| of the membrane | membrane |
|
|
| keyboard | keyboard |
NOTE
Before following the particular steps listed above in the troubleshooting guide for the membrane keyboard’s failure, please check for the continuity of each
20
