Instrucciones de Operación
Installation Instructions - Integrated Application
Almacenamiento de Vinos
¡IMPORTANTE!
• La capacidad máxima* de |
la DWC166BLSRH es de |
Para aprovechar la capacidad máxima de 166 botellas, éstas deben colocarse alternadamente en las trece (13) repisas superi- ores como se muestra en la Fig. C. Así se podrán almacenar once (11) botellas de 750 ml en cada una de las trece (13) repisas.
Fig. C
Tools You Will Need
WA R N I N G !
While performing the installations described in this section; gloves, safety glasses or goggles should be worn.
Safety Glasses | Gloves | Level |
|
| |
|
| Flashlight |
Carpenter’s
Square
Drill & Hole Saw set | Measuring |
Tape |
166 botellas de vino (de |
750ml). |
• Guarde el vino en botellas |
cerradas únicamente. |
Cada una de las dos (2) repisas inferiores tiene capacidad para siete (7) botellas de acuerdo a la
Fig. D.
La repisa superior tiene capaci- dad para veinte (20) botellas de vino cuando se colocan once
(11)botellas alternadas de acuerdo a la Fig. C; y luego otras nueve (9) botellas alternadas encima y entre las once (11) botellas de abajo, como se muestra en la Fig. E.
Fig. D
Preparing the Enclosure
Electrical Requirements
The appliance must be con- nected to an individual properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse.
• It is recommended that you |
do not install the wine cooler |
into a corner (i.e. directly |
beside a wall). This is to allow |
the door to have a greater than |
90° opening swing. A limited |
door swing will prevent the |
shelves from sliding out as |
intended, and may lead to |
damaging the door gasket. |
• The rough cabinet opening |
must be on a level floor area |
and at least 26 7/8” (68.26cm) |
deep* by 23 3/4” (60.33cm) |
wide. The opening should also |
•The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig. B).
Important: If the electrical outlet is surface mounted (not flush) within the enclosure, the depth requirement for the installation may be affected.
• If the electrical outlet is locat- |
ed inside the adjacent cabi- |
netry, cut a 11/2” (3.81cm) |
diameter hole to admit the |
Fig. E
IMPORTANT!
have a height of at least 69 3/4” |
(177.17cm). |
power cord. |
Fig. B
Do not include the door within the enclosure; leave it outside of the enclosure to prevent the door swing from being obstructed.
| 69 3/4”/ | } |
|
177.17cm |
| ||
|
| ||
} | 26 7/8”*/ |
|
|
68.26cm |
|
| |
|
|
| |
Electrical |
| Cabinets | |
Access: 2” / |
| must be | |
3.81cm |
| square | |
} |
|
| and |
|
|
| |
|
|
| plumb. |
| } |
| |
| 233/4”/ 60.33cm |
|
*The listed depth requirement for the installation is assuming that the electrical outlet is located in the adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.
32 | 5 |