STEP 2
Single Hose Installation (portable applications)Your washing machine is equipped with easy to install accessories allowing the washing machine to be connected to a single source water supply line;
Accessories Included:2 only Inlet Hose Fig. A
1 only Water Inlet Hose "Quick Connect". Fig. B
1 only Faucet Adapter. Fig. C
1 only Water Inlet Valve Cap/Plug. Fig. D
A | B |
Inlet Hose | Connector |
2PCS | 1PC |
CD
Hot Water
Connector
Cold Water
Connector
Important Notice: For portable installations (using a single inlet hose only) it will be necessary to "cap/plug" one side of the hot/cold water valve not being used. Fig. D
D | Cap/Plug | Hot Water |
| ||
| Connector | |
|
| |
| Water |
|
| Inlet Hose |
|
|
| Cold Water |
|
| Connector |
Failure to install the "cap/plug" on the open side of the water valve will result in leakage from the valve during any/all water fill cycles.
Special Note: Depending on which side of the (Hot/Cold) valve the cap/plug is installed, certain "WASH/TEMP" fill programs will not be operational. i.e.
•If you cap/plug the HOT WATER (upper) valve, it will not be possible to select the "COLD/COLD" WASH/TEMP water fill program. You can only select either the WARM/COLD or HOT/COLD WASH/TEMP water fill programs. (under the COLD/COLD setting no water will enter the wash tub)
•If you cap/plug the COLD WATER (lower) valve, it will not be possible to select the "HOT/COLD" WASH TEMP water fill program. You can only select either the WARM/COLD or COLD/COLD WASH/TEMP water fill program. (under the HOT/COLD setting no water will enter the wash tub)
Connecting the Water Inlet Hose:•Screw the faucet adapter onto the faucet. Fig. C (check for leaks, use Teflon tape to eliminate if necessary)
C
•Install rubber washer into each end of the fill hose. Fig. E
E
Rubber Ring
Connecting
Nut
Water
Inlet Hose
7