•Connect the opposite end of the fill hoses to their respective HOT & COLD water supply lines. Fig. I IMPORTANT: Make sure the HOT water line is connected to the HOT (upper) water valve and the COLD water line is connected to the COLD (lower) water valve. Fig. I
I
Connecting
Nut
Water
Inlet Hose
Tap
Connector
•Slowly open both water supply lines and check for any sign of leaks at all connection points.
•If leaks occur, immediately close the water supply lines and effect the necessary repairs and/or replacement of any/all defective connections.
•If you are unable to effect suitable repairs yourself, call our toll free CUSTOMER HELP LINE at "1 800 26 DANBY and ask for assistance.
STEP 3
Connect Drain Hose to DrainReceptaclePortable Installation: Hang the drain pipe over the edge of the wash tub and/or kitchen sink. Make sure the hose cannot be accidentally displaced when the drain water is being discharged.
Permanent Installation: Insert the end of the drain hose directly into the drain stem pipe and /or hang over the edge of the wash tub.
NOTE: The highest
point of the drain J hose must be positioned between
26" ~ 46" above floor level, otherwise the pumping out (efficiency) of the water may be affected. Fig. J
STEP 4
Levelling the Washing Machine.To prevent vibration and unnecessary movement during wash and spin operation, the washer must be installed on a firm and level surface, This is accomplished by using the level adjustment knob located on the lower right side of the cabinet. To change the height of the adjustment leg, unscrew the level adjustment knob, set the machine level and
The inclination angle of the washer shall not be more than two (2º) degrees.Place the washer at least 5cm (2") away from the wall.
M
Correct Incorrect
Loosen Tighten
Level
Adjustment Knob
Portable Installations: For portable applications, the washing machine comes equipped with four (4) "north/south" casters that can easily be installed to assist in the movement of the machine too and from the sink. Lay the unit on its back.
Install the casters into the bottom of the base as depicted. Fig. N
N
Fixed foot | Adjustable Foot |
Castor | Castor |
| |
Castor | Castor |
| |
Fixed Foot | Fixed Foot |
Return the machine to the upright position.
When the machine is positioned for operation, set the height of the adjustment leg slightly higher than the front caster to prevent movement of the machine during wash and spin operation.
NOTE: Not all movement will be totally eliminated, this is normal.
9